When do I use a cup, a pull and a knob ?
The traditional application is to use a cup or a pull for the cabinet drawers and a knob for the hinged cabinet doors. On wide drawers, it is also common to mount two knobs.
To open big refrigerator/appliance doors with fabricated cabinet panels, longer and larger pulls are being used to allow for greater leverage. These pulls range anywhere from 8″ to 24″ long and upwards.
Cliffside has an extensive line of knobs, cups, pulls and appliance pulls available in traditional, classic and designer styles, a variety of high quality materials including stainless steel and solid brass and in up to 10 popular finishes. Break-off screws are included with all Cliffside hardware.
Professional installation is advised for all hardware.
Cups and Pulls
For cabinet drawers
The optimum placement of cups and pulls is to find the spot slightly above the center line (vertical) on the drawerand the spot that makes the pull look like it is centered when the cabinets are viewed from above (as if you were standing at the countertop looking down). The amount of offset is up to the installer, but starting with 1/16″ and up is a good place to start.
Using a Phillips head screw driver and the standard thread 8/32 x 1¾” break off screws included with your hardware, mount the drawer cup or pull on the face of the cabinet. Turn the screw into the socket clockwise.
For hinged doors
Avoid placing the pull in the corner of the door frame. We recommend placing the pull in the upper third, but with many traditional-style cabinets a pull in the center of the door stile (vertical) can be pleasing.
We recommend utilizing your appliance manufacturer’s installation/design guide for mounting instructions. Professional installation is especially advised for all appliance hardware.
The optimum placement of appliance pulls on hinged doors is when the center of the door hardware is at elbow height of the adult users in the home. This allows the lowest part of the handle to be used by children comfortably.
The optimum placement of pulls on appliances should be in the center of the appliance panel’s top rail, regardless of width.
For both hinged door and drawer panels, we recommend mounting our hardware slightly away from the panel edge. This allows a little more finger clearance on these larger pulls
For wide cabinet drawers
Avoid mounting them too widely or narrowly. The optimum placement of two knobs on wide drawers is the center of the door below (if applicable) and align vertically with the outer third of each door. If there are only more drawers below, then measure the drawer into thirds to find the best spot.
For base cabinet drawers
The optimum placement of a knob on a base cabinet drawer is slightly above the center line (vertical) on the drawer. This helps make the knob look like it is centered when the cabinets are viewed from above (as if you were standing at the countertop looking down). As with any pull, the amount of offset is up to the installer, but 1/16″ and up is a good place to start.
For hinged doors
We recommend placing the knob on a hinged doors in the upper third of the door face. Both options provide more leverage. Using the corner of the door to install hardware can cause weakness in the hinges over repeated use, so as with a pull, we suggest avoiding that particular location.